In this tutorial, we’ll go through how to Setup Victure WE300 extender. The Victure WE300 extender boosts signal strength in your neighborhood. It has high-speed and consistent signals, as well as dual extender antennas and a data transmission rate of up to 300 Mbps. The reliable network is provided by 2.4 GHz, 3000 Mbps, WPS, and Ethernet port AP mode. This increases Wi-Fi range coverage and provides a strong and consistent Wi-Fi signal to prevent lagging and buffering when working online. As a result, you’ll be able to enjoy high-definition streaming, gaming, surfing, and broadcasting. Additionally, simple configuration via your existing router via WPS allows you to extend the signal to dead zones. The Wi-Fi range extender’s Victure Ethernet ports can be used as a wireless adaptor to connect wired devices like game consoles, printers, wireless security cameras, and smart TVs. This is all about the Victure WE300 Extender’s characteristics.
Via a web domain, setup the Victure WE300 Extender.
To Setup Victure We300 Extender through web domain, follow the instructions below:
- To begin, plug your Victure We300 extender into a wall outlet.
- Then hold on for 40 seconds till the LED lights up.
- Once you’ve seen what you’re looking for, connect your device to your wireless network.
- The smartphone will use the SSID WIRELESS-XXXX and the password will be null.
- After your device got connected, open any web browser on it.
- Type http://wireless.repeater into the address box and press enter.
- You will now be taken to the login page.
- Then, as admin, type in your username and password and hit enter.
- The setup page will appear here.
- Enter the language you want to use.
- Go to the settings page, choose your home Wi-Fi router, type in the password, and then click Next.
- To complete the configuration, click the button at the bottom.
- After then, the Victure repeater will start up again.
- The configuration of the Victure Extender has been completed successfully.
Use WPS to Setup the Victure WE300 Extender.
To use the WPS button to set up the Victure WE300 extender. Follow the procedures below carefully; this is the simplest approach of them all.
- You must first unbox your Victure extender setup.
- Then, turn on the Victure extender.
- Once you’ve confirmed that the extender is turned on, look for the WPS on the Extender.
- Now, for around 2 minutes, press and hold the WPS button on the Extender.
- Within 2 minutes, press and hold the button on your router as well.
- The repeater’s LED will begin to blink throughout this operation.
- Your device has now been successfully linked.