Click on setup button to start setup process
Getting the error message ‘Pix-link Wi-Fi Repeater Login page not working’ on a regular basis. If the notice “you are not connected to the extender’s WiFi network” appears on your computer’s screen on a regular basis, you may have a problem. If that’s the case, you’ll find the information in this post quite beneficial. A few tried and tested solutions for troubleshooting PixLink extender login issues are provided below. If none of the above methods work, please let us know. Continue to read!
- The Wi-Fi repeater should be put into an electrical socket.
- Make that the power LED on the repeater is solid green.
- Open the Wi-Fi settings on your computer or laptop and connect to the Pix-link WiFi repeater.
- Open a browser such as Chrome, Explorer, or Firefox and type myrepeater.net or 192.168.10.1 into the address bar.
- The login screen requests a username and password, which are both set to admin by default.
How to Setup myrepeater.net using your smartphone?
The Pix-link Wi-Fi Repeater comes with a loose Ethernet cable. You can use that cable to connect to the computer via a hardwired connection.
- To connect the repeater to the PC or laptop, utilize an Ethernet cable.
- To access myrepeater.net or 192.168.10.1, use a browser such as Chrome, Internet Explorer, or Firefox.
- The login screen for the Pix-link Wi-Fi Repeater will open, prompting you to enter your username and password.
- For both, the default username and password are admin.
- Then log in to the Pix-link repeater page and submit your credentials.
How to Setup myrepeater.net once the repeater has been setup?
If your Wi-Fi repeater is up and running and you wish to access the myrepeater.net page again, follow these steps.
- Your Wi-Fi repeater must be compatible with your current router.
- Your computer or laptop must be on the same network as the router.
- Go to the router’s login page and log in. If it asks for a username and password, check the router label for the same information.
- Now go through the router’s client list for the Pix-link Wi-Fi Repeater IP address.
- In a browser, go to the same IP address and log in with the repeater username and password.
Pix-Link Repeater Setup using setup.pix-link.net
Via setup.pix-link.net, the Pix-Link wireless repeater is incredibly straightforward to set up. There are two ways to set up the repeater. With a consistent signal and 360° of coverage, the Pix-Link WiFi range extender increases the speed of current WiFi to 1200Mbps. The steps are listed below.
- Connect to the PIX-LINK-2.46/PIX-LINK-5.8G network to access the repeater’s network with your PC or mobile device. 12345678 is the factory default password. Disconnect your computer from the Internet if it has an Ethernet connection. The repeater’s bottom label shows the default wireless name.
- Simply launch your favourite web browser and go to setup.pix-link.net or 192.168.7.1. Please enter the following password to continue: admin.
- Go to the menu and choose Repeater Mode.
- On its own, the device can find neighboring wifi networks.
- After choosing the Home WIFI, enter the repeater SSID and password. The repeater’s SSID by default is xxxx-2.4G-EXT. To complete the setup, click Apply.
- Please remember that the pass phrase is the same as the password for your home router.
- The repeater LED ought to be solidly on if your router and repeater can successfully communicate.
- Midway between your router and the spot with bad Wi-Fi, connect the repeater. Your router must be reachable from the location you’ve chosen. Watch for the signal LED to turn solid blue in around two minutes. If not, try moving the repeater closer to the router to boost the signal.